Sewing--esp for structured suits which I no longer need and make.

AI Overview

How to use Fusible Interfacing

To attach fusible interfacing, place the interfacing's textured, glue-dot side down onto the wrong side of your fabric. Cover with a press cloth, then use a hot iron to press firmly in sections for 10-15 seconds, lifting the iron between each press instead of sliding it. Repeat until the entire piece is adhered, then allow it to cool completely.

Step-by-step guide

This video demonstrates the entire process of applying fusible interfacing:

Related video thumbnail 1m Professor Pincushion YouTube • Dec 7, 2011

Prepare the fabric and interfacing:

Ensure the fabric has been pre-treated before starting.

Cut the interfacing to the same size as your fabric, or trim if your pattern specifies.

Identify the textured, "bumpy" side of the interfacing, which is the adhesive side.

Position the interfacing:

Lay the main fabric piece right side down on your ironing board.

Place the interfacing, textured side down, onto the wrong side of the fabric, aligning the edges.

Set up for ironing:

Place a dry, lightweight press cloth over the interfacing to protect your iron and fabric.

Set your iron to the heat setting recommended for your fabric type (e.g., cotton, wool). A steam setting is often recommended.

Press the interfacing:

Place the iron on one section of the fabric and press down firmly for about 10-15 seconds.

Lift the iron straight up, without sliding, and move it to the next section, overlapping slightly with the previously pressed area.

Continue pressing and lifting until the entire piece is fused.

Check adhesion and cool:

A

fter pressing, allow the fabric to cool completely while lying flat.

Check the edges to ensure the interfacing is fully bonded. If needed, press the edges again.